+ETM Unsolicited Response Codes (URCs)

AnyNet SMARTconnect™ adds the following Eseye URCs to the module.

You will continue to observe other URCs from the module.

For information about all other URCs, see the relevant module documentation.

URC Description

+ETM:EMQRDY

ETM has entered MQTT mode and is ready to accept any AT+EMQ... commands. Prior to this, only AT+ETM... commands are accepted.

+ETM:IDLE

The modem has started up and is ready for commands.

+ETM:REBOOTING

The modem will shortly restart. Wait for +ETM:IDLE before sending commands. Configure automatic rebooting using update_autoreboot in the configuration file. For more information, see Using AnyNet SMARTconnect™ configuration file.

+ETM: REBOOT REQUIRED

The modem has received an update and needs to restart. While operation can continue as normal, the host should issue AT+ETMRESET at a convenient time. This restarts the device and applies the update.

Configure automatic rebooting using update_autoreboot in the configuration file. For more information, see Using AnyNet SMARTconnect™ configuration file.

+ETMSTATE:<StateID>

where <StateID> is the current connectivity state of the module.

Enable this response using the AT+ETMSTATE write command. For more information, see ETMSTATE – check current state.

+ETM:SYSSTART

 Indicates that AnyNet SMARTconnect™ application has started.

Where to next?