ETMCFG – read and write configuration file values
Read and write configuration file values. For information about the configuration file parameters, see Using the Cinterion® ELS61 Wireless Module configuration file.
Read
AT+ETMCFG?
Write
AT+ETMCFG=[<cmd>,][<section>,<parameter>[,<value>]]
where:
<cmd> is the command in lowercase, either:
default– resets the configuration file values to the default firmware values in the factory settings. After resetting to default, send thesave<cmd> to keep the default settings, then reboot the modem.get– returns the current configuration value for the requested parameters.revert– undoes any changes to the values in the configuration file up until the last save. If you want to keep the reverted values, send thesave<cmd>, then reboot the modem.save– saves the current configuration values as a new version. After saving, you must reboot the modem to apply the changes.Tip: Use
AT+ETMRESETto reboot the modem.show– returns the entire current configuration file content. The response is sent as multiple URCs, with each line beginning+ETMCFG.
If you do not supply <cmd>, the value is applied to the configuration file in the following format:
AT+ETMCFG=<section>,<parameter>,<value>
where: section is the configuration file section, parameter is the parameter name, and value is the new parameter value.
OK
or
ERROR
Examples
AT+ETMCFG=get,mqtt,urcautoformat
OK
+ETMCFG: 0
AT+ETMCFG=mqtt,keepalive,1800
OKLast updated
Was this helpful?